How To Light A Gas Water Heater Pilot Light. Before starting the procedure for relighting the pilot on your gas water heater, you want to make sure that the gas valve is open. On most furnaces, you’ll spot a small valve near the bottom of the unit with three positions:
Turn the gas valve to ‘pilot’. Press and hold the control knob to let the gas flow into the pilot light. When the gas burner comes on, use a 50/50 dish soap/water mix to test the screw joints for air bubbles that indicate leaks.
Table of Contents
Here Here’s How To Light The Pilot Light On A Rheem Gas Water Heater.
As you’re holding down the knob, light the pilot light. But, if the thermocouple is dirty or worn out, it may not respond to the heat and then shut off the gas. Use either a lighter, match or candle to provide the flame required to relight the pilot light.
Turn The Gas Knob To “Pilot,” Press And Hold It Down.
On most furnaces, you’ll spot a small valve near the bottom of the unit with three positions: While still holding the gas down, light that pilot.; Do not attempt to manually light an electronic ignition system.
Some Water Heaters Have A Red Or Black Igniting Button, And Others.
Check that gas is flowing. The knob can’t be turned from “pilot” to “off” except the knob is depressed barely. Running out of fuel is a relatively easy fix that requires you to purchase a new propane tank or turn on your gas and relight, but there could be some other issues at work, especially if the pilot light has gone out more than once in a short.
Turn The Gas Valve To ‘Pilot’.
This will ensure the pilot remains lit. Once in the pilot position, press the control knob down fully and keep holding it down for 30 seconds. In some cases, your hot water heater will have a separate pilot button.
Turn The Gas Valve To “Pilot” And Press Down.
This will start the flow of gas so you can light the flame. Standard procedure to light the pilot before starting: February 17, 2022 by allison hayes.