How To Reset Oil Change Light On Jeep Wrangler. What am i not doing correctly. Turn the key to the off position and then back on to confirm reset was accepted.
Now turn the key to the off position. If necessary, repeat this procedure. Turn the ignition key to position “run” without starting the engine, if your vehicle has a smart key button, press the “start” button twice without touching the brake pedal.
Table of Contents
What Am I Not Doing Correctly.
Without starting the engine, turn the ignition in the on/run mode position. You can reset the engine oil change light on the jeep wrangler by following these steps. Once done, you can verify it’s good to go by navigating in the menu system to see that the oil life is back to 100%.
Start The Vehicle, The Oil Change Indicator System Did Not.
When the pcm detects any problems it sends a code that is displayed in your instrument panel. Fully depress the gas pedal slowly three times within 10 seconds. Insert the key into the ignition and turn it to the “on” position without starting the engine.
How To Reset Jeep Wrangler Oil Light After Oil Change:
Press and hold the “ ok ” button until the oil life is reset to 100%. Turn the ignition off and start the engine to verify the indicator has been reset. Next, push the button to start the ignition, then press it twice to enter a run position.
Hope You Like The Video!
This action will power the jeep. To reset the 2015 jeep wrangler oil change required light, please follow these instructions:turn the ignition to run (one position before starting engine).fully depress the accelerator pedal slowly three times within 10 seconds.turn the ignition off and then start the engine to verify the indicator has been reset.apr 18, 2021 If the oil change light reset procedure is not working to reset your oil life monitor, make sure you are following each of the steps exactly and in the order displayed in the oil change light reset jeep wrangler.
Switch The Ignition Off And Start The Engine To Confirm If The Indicator Has Been Reset.
It’s very easy to reset your oil change light on the jeep wrangler jk. Switch the ignition off and start the engine to confirm if the indicator has been reset. As soon as the chimes stop, depress the gas pedal all the way to the floor three times within 10 seconds.